H&C 20.003214 Concrete Stain Solid Color, 1 Gallon Cheap Online Store Manchester

H&C Concrete Stain Solid Color Water-Based (formerly known as Shield Plus Ultra) is a low odor, water-based stain that provides long-lasting, durable and a decorative finish to interior or exterior concrete and masonry surfaces.  H&C Concrete Stain Solid Color Water-based is highly resistant to pool chemicals.

Where to Use:

• Pool decks
• Patios/Walkways
• Interior floors (laundry rooms, basement floors)
• Stadium supports and parking garages
• Athletic courts
• Block and stucco walls
• Asphalt driveways and properly prepared concrete driveways
• CMU, split face and fluted block
• Precast, poured in place, and tilt-up concrete
• Pack of 4

Highlights:

• Color Ultra Deep Base
• Gallon

Key Advantages:

H&C Concrete Stain Solid Color Water-Based bonds to concrete and forms a tough shield so it doesn’t fade, peel or flake like paint and is low odor.  It is resistant to acids, ultraviolet rays, oil, gas and alkali while maintaining a decorative finish.  Available in a variety of ready-to-use and tintable colors, as well as a clear, this stain is ideal for high pH surfaces.  Fortified with silicone, this easy to apply solid color stain comes in 8 prepackaged colors, or 82 tintable colors!

How To Apply

1. Product Supplies

• Stiff broom
• Nylon/polyester brush
• Soft woven roller cover, 3/8″ – 1/2″ nap
• Roller frame
• Paint tray/liner
• Airless Sprayer  Pressure: 1500 psi Tip: .013″ – .017″  Conventional Sprayer Air Pressure: 30 – 50 psi Fluid Pressure: 15 – 20 psi Cap/Tip: 704/FX or equivalent High-Volume Low Pressure Sprayer Cap/Needle: Titan #3 or equivalent

2. Product Preparation

Due to a wide variety of substrates, preparation and application methods and environments, test the product in an inconspicuous spot for adhesion and compatibility prior to full scale application.  All surfaces must be clean, dry and free of grease, oil, paint, sealers, etc. 

Newly poured concrete must cure for at least 45 days.  Concrete must be etched with H&C Concrete Etching Solution, follow label instructions. Surface should feel like 120-grit sandpaper, if not, then etch again.  Allow 24 hours to dry prior to staining. 

Asphalt:  must be free of dirt, oil, grease, wax etc.  Scrub with H&C Cleaner Degreaser, following label instructions.  DO NOT ETCH ASPHALT. We do not recommend staining if asphalt has been freshly sealed. 

Previously painted: all old, peeling or flaking paint must be removed.  Areas with firm adhesion must be clean and free of dirt, oil grease etc.  Clean with H&C Cleaner Degreaser, following label instructions.  Rinse thoroughly and allow to dry.  The remaining paint/coating should be rough sanded in a circular motion to ensure adhesion of H&C Concrete Stain Solid Color Water-based.  Rinse away sanding dust.

3. Product Application

Air and surface temperature should be between 50 and 90